Customizable cases for the raspberry pi 3b and 4.
Main reason for the remix was to fit a zigbee module with external antenna into it.
Credits go to the OpenScad model by George Raven found here: https://www.prusaprinters.org/prints/4678-ravenpi-raspberry-pi-4-case
- Added tolerances: (my raspberry did not fit in the original model)
- to the board dimension itself
- to all the connector cutouts
- Adaptions for a CC2652P2 zigbee module:
- Increased the height of the case to fit the module into it
- decreased the size of the hole for the GPIO pins in the area covered by the module
- added an antenna holder for this antenna adapter
- Added support for raspberry pi 3
- Added Customizer support