VESC Scooter Support

Allows you to connect your XIAOMI or NINEBOT display to VESC controller.

How

Do you want to use your Xiaomi or NineBot BLE with a VESC controller? This is the right place for you!
Read one of the guides below to get started.

• DE Guide
• German Rollerplausch Guide

Which version should I use?

If you are running VESC 7.00, use these:

• M365: https://github.com/1zun4/vesc_scooter_support/blob/main/g30_dash.lisp
• G30: https://github.com/1zun4/vesc_scooter_support/blob/main/g30_dash.lisp
• How-To Video: https://www.youtube.com/watch?v=kX8PsaxfoXQ

How do I wire it?

Red to 5V
Black to GND
Yellow to TX (UART-HDX)
Green to RX (Button)
1k Ohm Resistor from 3.3V to RX (Button)

Features

• Multiple speed modes (Press twice)
• Secret speed modes (Hold throttle and brake and press twice)
• Lock mode with beeping and braking (Press twice while holding break)
• Motor start speed feature (More secure)
• Shutdown feature (Long press to turn off)
• Battery Idle % on Secret Sport Mode
• Temperature notification icon at 60°C

Features to be added:

• App communication
• More unlock combinations

Tested on

BLEs

• Clone M365 PRO Dashboard (AliExpress)
• Original DE-Edition PRO 2 Dashboard
• Original DE-Edition G30 Dashboard

Known compatible VESCs

• Spintend (Reliable & High Performance):

  • Ubox Single Lite 100V 100A
  • Ubox Single 85V 250A V2

• Makerbase:

  • Makerbase VESC 60100HP V2 60V 100A
  • Makerbase VESC 84100HP 84V 100A
  • Makerbase VESC 84200HP 84V 200A

• 75100 Alu PCB (Not recommeded):

  • Makerbase 75100 Alu PCB
  • Flipsky 75100 Alu PCB

• More recommended VESCs:

  • MP2 300A 100V/150V VESC
  • and many more... use whatever you like.

Requirements on VESC

Requires 7.00 VESC firmware.
Can be found here: https://vesc-project.com/

Worth to check out!

https://github.com/Koxx3/SmartESC_STM32_v2 (VESC firmware for Xiaomi ESCs)